Miniland digital camera 4.3' pro Manual Del Usuario página 16

ENGLISH
PROBLEM POSSIBLE CAUSE
The camera and monitor may be
too far apart.
Camera has no battery.
If the baby unit has
lost connection
with the parental
Connection between the two units
unit.
is momentarily lost.
The connection between the two
units is lost.
8. TECHNICAL SPECIFICATIONS
Frequency
Operating Range
Nº of configurable channels
Rechargeable camera battery
Power (baby unit) Output:
Power (baby unit) Input:
Operating time with battery fully charged (baby
unit)
9. PRODUCT DISPOSAL INFORMATION
· Remember to dispose of the product responsibly.
· Do not mix products bearing the crossed -out bin
symbol with your general household waste.
· For the correct collection and treatment of these
products take them to the collection points designated
by your local authority. Alternatively contact the retailer
who sold you the product.
SOLUTION
Extend the monitor antenna (15), and in case
it is still out of range move the monitor closer
to the camera.
Plug in power adapter.
Restore the units by disconnecting them from
the power supply.Wait about 15 seconds before
reconnecting them.Allow one minute for the
baby unit and the parent unit to synchronize.
Pair the camera and monitor again.See section
5.2.4.
2.4GHz FHSS
240m (straight line and open space)
2
3.7V 950 mAh
100-240 V CA - 50/60 Hz
5 V – 1A
Approximately 4 hours
Hereby, Miniland S. A. declares that
this "89508 digital camera 4.3'' pro"
is in compliance with the essential
requirements and other relevant
provisions of Directive 2014/53/UE.
16