Publicidad
Idiomas disponibles
Idiomas disponibles
5. EMITTERS
5.1 Emitters
You can program any of the four transmitter pushbuttons.
If a single transmitter button is programmed, it will work in step-
by-step mode: one press opens, the next one stops, the next one
closes, and so on. The control circuit can memorize up to 25
transmitters.
If more buttons of the same transmitter are programmed, these
will work as follows:
Button 1: step by step cycle
Button 2: pedestrian opening (only one leaf)
Button 3: just close
Button 4: no functions
5.2 Emitters programming (learn).
Press the AN1 button on the control circuit.
The LEARN light on the control board lights.
Press for 1 second the key of the transmitter you want to use in order to activate the motor.
The led starts flashing and then turn off.
Programming is over. The system works with the transmitter.
5.3 Erase emitters
The deletion process removes all emitters from the motor memory. Individual
transmitters can not be erased.
Press the AN1 button on the control circuit and keep it pressed. The LED2 light comes
on. Release the button when the light is off.
The emitters have been erased.
Note: After installing or powered off the motor, make a complete maneuver (open and
close) pressing the emitter button or an external button. The control board will
memorize the distance and the soft stop function will be activated in the next maneuver.
11
Publicidad
