Publicidad
Idiomas disponibles
Idiomas disponibles
14. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, any adjustment on the Pitchfader will have no effect.
15. PITCH BEND-BUTTONS
The player must be in the playback mode. The playback-speed can temporarily be changed by +/- 16 %.
16. RELAY-BUTTON
By pressing the RELAY-button, the playback automatically switches to the other player after every track.
Please refer to 6.8 Relay-operation.
Rear panel:
17. CONNECTOR PORTS
Connect the Dual CD-Player here.
18. CONTROL-SOCKETS
Via the Control-socket, the respective CD-player can be remotely controlled. If you are using a mixer with
Faderstart-function connect the player with the Control Out-socket. Please note that these sockets must
never be connected with any voltage. Please refer to 6.9 Faderstart.
5. INSTALLATION
Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.
All manuals and user guides at all-guides.com
CONNECT
TO MAIN UNIT 2IT
FAD ER
2
CUE - ST ART
CONTROL
17
18
24/51
CONNECT
TO MAIN UNIT 1IT
FAD ER
1
CUE - ST ART
CONTROL
17
18
1060225N_V_1_0.DOC
Publicidad
