Craftsman CMXGZBF7124489 Manual De Instrucciones página 4

ENglISh
ASSembLy
Step 1: (fig. 1)
1. Place the foot pedal through the slot in the tongue.
Assemble the hex bolt (D) through the tongue, the foot
pedal, and two hex nuts (H) placed on each side of the
foot pedal. Assemble the hex nut (G) onto the end of the
hex bolt (D) and tighten so that the hex bolt (D) can still
rotate freely. Tighten the two hex nuts (H) against each
side of the pedal so that the pedal is centered in the slot.
Fig. 1
(D)
Step 2: (fig. 2)
1. Hook the short end of the spring (M) into the hole in
the foot pedal . Use the spring puller tool (O) to hook
the long end of the spring into the square hole in the
tongue. The spring puller tool can be stored when
finished.
Fig. 2
2
(H)
(G)
(O)
Step 3: (fig. 3)
1. Assemble the hitch bracket to the tongue using two hex
bolts (C) and hex nuts (I). Tighten.
2. .Assemble the hitch pin (L) through the tongue and
hitch bracket and secure it with the hair cotter pin (J).
Fig. 3
(C)
(I)
Step 4: (fig. 4)
1. Lay the tongue (open side facing up) onto the wheel
support. Assemble the axle through the wheel support
and the tongue.
Fig. 4
Step 5: (fig. 5)
1. Assemble an axle clip (N), a washer (E), a wheel with the
valve stem facing out, and another washer (E) onto the
axle. Secure them in place with a 1/8" x 1-1/4" cotter pin
(K). Repeat for other wheel.
Fig. 5
(E)
(K)
(L)
(J)
Use these holes
(E) (N)