Beamz professional LED Cub4 2 x10W + 64xLED DMX Manual De Instrucciones página 6

SPECIFICATIONS :
Supply Voltage: ................................................................... AC110～240V 50/60HZ
Power: .................................................................................................................. 50W
LED: ................................ 5mm LED R 16PCs, G 16PCs, B 16PCs, A 8PCs, W 8Pcs
.......................................................................................... 2×10W LED 4-IN-1 RGBW
Fuse: ....................................................................................................................... 3A
Control Signal： .......................................................................................... DMX signal
Channel：....................................................... 10 Channels
Function：...........................................DMX512, Auto-run, Sound active, Master-Slave
Dimensions : .............................................................................. 277 X 277 X 320mm
Weight : .............................................................. 4 kg
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration and
slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and is able to support a
weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times of the weight of the unit when
installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of people and has no one
pass by or under it.
How To Control The Unit
Three ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
A. Master/Slave operation
The unit can be linked together in daisy chain in master/slave mode to perform the great built-in pre-programmed lighting shows
triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: when working at Auto-run or Sound Control mode operation
Slave units: DMX start address MUST be set to d001.