Publicidad
display installation
Attach Brackets to Display
Check depth of screw threads in display before inserting screws. Inserting a screw that
is longer than the hole could result in damage to display. Depth can be confirmed by
inserting hex wrench into hole and marking its length then confirming this length is
sufficient by comparing it to the screw you are using.
Install interface mounting brackets (O) onto display as shown using supplied phillips
screws (G) or screws specified by the display manufacturer. Hand tighten first
to confirm thread and depth match. Note: Affix display brackets "Ears-Out" as shown
Ears out
Salamander Designs - Electric Lift, Mobile Display Stands Designed for Surface
www.salamandercommercial.com
501-675-MS [7.20]
page 7 of 24
Publicidad
