Publicidad
Idiomas disponibles
Idiomas disponibles
7. Check Operation
Refer to the User Manual packaged with the
appliance for operating instructions and for care and
cleaning of your cooktop.
CAUTION!
Do not touch the burners. They may be hot
enough to cause burns.
1. Check Burner Cap Placement Regular burner
It is very important to be sure that all surface
burner caps and burner grates are properly installed
and in the correct locations before operating the
appliance.
The cooktop is not removeable. Do not attempt to
remove or lift the cooktop.
WARNING!
To prevent flare-ups and avoid creation
of harmful by-products, do not use the
cooktop without all burner caps properly
installed to insure proper ignition and gas
flame size.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use. Do
not allow spills, food, cleaning agents or any other
material to enter the gas orifice holder openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
sure that all round style burner caps are correctly in
place on round burner heads.
Check and be sure that all oval style burner caps
are correctly in place on oval burner heads (if
equipped). Check and be sure that all dual or twin
style burner caps are correctly in place on dual or
twin burner heads (if equipped).
On round style burners, the burner cap should fit
snug into the center of burner head and be level.
Refer to Figure 11 for correct and incorrect burner
cap placement.
Once in place, you may check the fit by gently
sliding the burner cap from side to side to be sure it
is centered and firmly seated. Please note that the
burner cap should NOT move off the center of the
burner head when sliding from side to side.
Burner Cap
Burner Head
Orifice Holder
Ignitor
Figure 11
2. Turn on Electrical Power and Open Main
Shutoff Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked
after range and supply line connectors have been
carefully checked for leaks and range has been
connected to electric power.
a. To check for proper lighting, push in and turn a
surface burner knob to the LITE position. You
will hear the igniter sparking.
b. The surface burner should ignite when gas is
available to the burner. Purge air from supply
lines by leaving knob in the LITE position until
burner ignites. Each burner should light within
four (4) seconds in normal operation after air
has been purged from supply lines.
c. Visually check that burner has a flame, Once
the burner ignites, the control knob should be
turned out of the LITE position.
d. Try each surface control knob separately until all
burner valves have been checked. Each burner
location is equipped with a separate electrode.
13
Publicidad
