Publicidad
Idiomas disponibles
Idiomas disponibles
CULTIVATING
Cultivating
is destroying
the weeds
between rows to prevent them from
robbing nourishment
and moisture from
the plants. At the same time, breaking up
the upper layer of soil crust will help
ADJUSTWHEELS
FOR
CULTIVATING
1. Place blocks under right hand side of
tiller and remove hairpin clip and
clevis pin from right hand wheel.
2. Move wheel outward approximately
1
inch until hole in inner wheel hub
lines up with inner hole in axle.
3. Replace clevis pin and hairpin clip on
inside of wheel and remove blocks.
4. Repeat preceding
steps on left hand
side.
NOTE:
In extremely
rough conditions
and while cultivating,
the wheels should
be moved outward on the axle for
increased
stability.
OUTER VIEW OF TIRE
retain moisture in the soil. Best digging
depth is 1" to 3" (2.5-7.5 cm).
Lower the
Clevis
outer side shields to protect small plants
from being buried.
• Cultivate up and down the rows at a
speed which will allow tines to uproot
weeds and leave the ground in rough
condition,
promoting
no further growth
of weeds and grass.
Pin
_,_
Hairpin Cllip
Clevis
Pin
INNER VIEW OF TIRE
TINE SHEAR PINS
The tine assemblies
on your tiller are
secured to the tine shaft with shear pins
(See 'q-INE REPLACEMENT"
in the
Service and Adjustments
section of this
manual).
If the tiller is unusually
overloaded
or
jammed,
the shear pins are designed to
break before internal damage occurs to
the transmission.
• If shear pin(s) break, replace only with
those shown in the Repair Parts
section of this manual.
Hairpin
12
Publicidad
