Craftsman 126.32565 Manual Del Operador página 22

and properly supporting the workpiece.
4. Support the saw so the machine table is
level and the saw does not rock.
5. Bolt or clamp the saw securely to its
support stand or workbench.
For portable use:
1. Mount the saw on a 3,4in. thick piece of
plywood using appropriate fasteners (not
supplied).
2. It may be necessary to countersink the
washers, nuts etc to the underside of the
plywood mounting board to avoid an uneven
work surface.
3. Use 'C'- clamps to attach the mounting
board to the work surface at the work site.
(Fig. L)
(Fig. L)
ADJUSTMENT INSTRUCTIONS
_l_ WARNING
To avoid injury from electric shock or
from an accidental start, make sure the
switch is in the OFF position and the plug
is not connected a power source outlet.
NOTE: When checking angular alignments
the Cutting Head should be lowered and
locked in the down position with the latching
pin fully located in its socket.
Refer to 'Locking the Cutting Head in the
down position' page 18
0° Bevel Stop Adjustment
1. Ensure that the Cutting Head is upright
against its stop and the Bevel Pointer is
indicating '0°' on the scale.
(Fig. M)
(Fig. M)
22