Publicidad
Idiomas disponibles
Idiomas disponibles
Installation & Assembly
The air compressor should be turned off, unplugged from
the power source, the air bled from the tank and the unit
allowed time to cool before any maintenance is performed.
Personal injuries could occur from moving parts, electrical
sources,
compressed
air or hot surfaces.
The quick
connect
assembly must be attached
before use. Failure
to assemble
correctly could result in leaks and possible
injury. If unsure of assembly instructions or you experience
difficulty
in the assembly
please call your local service
department for further information.
j..J
,,i
Grounding Pin
Grounded
Outlet
Getting Started = Location of the Air Compressor
The air compressor should always be located in a clean,
dry and well ventilated environment. The unit should have
at minimum, 12 inches of space on each side. The air filter
intake should be free of any debris or obstructions.
Check the air filter on a daily basis to make sure it is clean
and in working order.
Risk Of Fire Or Explosion
This product
incorporates snap
action switch
contacts
and a universal electric motor which tend to produce arcs
and sparking
and therefore
should
not be exposed
to
flammable liquids or vapors. This product is not intended
for installation
or use in a commercial
garage or shop
environment.
Improper installation of the grounding plug will result in a
risk of electric shock. If repair or replacement of the cord
or plug is necessary, do not connect the grounding wire to
either flat blade terminal. The wire with insulation having
an outer surface that is green with or without yellow stripes
is the grounding wire. Check with a qualified electrician or
serviceman if the grounding instructions are not completely
understood,
or if in doubt as to whether the product is
properly grounded. Do not modify the plug provided.
If it will not fit the outlet, have the proper outlet installed
by a qualified electrician.
This product is for use on a circuit having a nominal rating
of 120 volts and is factory-equipped
with a specific electric
cord and plug to permit connection
to a proper electric
circuit. Make sure the product is connected
to an outlet
having the same configuration
as the plug. An adapter
should not be used with this product. If the product must
be reconnected for use on a different type of electric circuit,
qualified service personnel should make the reconnection.
Grounding Instructions
This product should be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current.
This product is equipped with a cord having a grounding
wire with an appropriate
grounding
plug. (See the figure
below.) The plug must be plugged into an outlet that is
properly installed and grounded in accordance with all local
codes and ordinances. Check with a qualified electrician or
service personnel if these instructions
are not completely
understood or if in doubt as to whether the tool is properly
grounded.
Extension
Cords
Use only a 3-wire
extension
cord that has a 3-blade
grounding plug and a 3-slot receptacle that will accept the
plug on the product. Make sure your extension
cord is in
good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product
will draw. Cords must not exceed 25 feet and No. 12 AWG
size must be used. An undersized cord will cause a drop
in line voltage resulting in loss of power and overheating.
Break In Procedures
No break in procedure is required by the user.
This product isfactory tested to ensure proper operation and
performance.
Publicidad
