Domo DO7115S Manual De Instrucciones página 40

DECALCIFY
When the descale indicator light comes on, you know it is time to clean the boiler. It is then essential to
rinse out this reservoir to prolong the life of your steam generator and avoid limescale deposits.
Self-cleaning function
1. After about 11 ironing hours, the indicator light above the self-cleaning button will start to
illuminate. This indicates that you need to clean the iron.
2. Place the iron over a sink.
3. Turn the temperature knob to position 'Max'.
4. Make sure there is water in the water tank.
5. Hold down the self-cleaning button for a few seconds. When the buzzer sounds, it's best to stay at a
safe distance away so you don't burn yourself on the hot steam.
6. The pump will run water through the iron causing it to clean itself. This takes about one minute.
7. After about 2 minutes, the cleaning is complete and the appliance can be used again.
If the indicator light remains on, repeat the descaling procedure.
ATTENTION: Use only tap water (or 50% tap water and 50% demineralised water in case of hard water) in
your steam generator.
Caution: softened water should absolutely be avoided! Using a "softener" and/or scented water may
cause brown stains, resulting in damage to the steam chamber.
PROBLEM AND SOLUTION
Problems
The appliance
leaks water from
the holes in the
ironing soleplate
Brown liquid
comes out of the
ironing soleplate.
The ironing
soleplate is dirty or
brown
40
DO7115S
Possible causes
1. The set temperature is too low
2. The iron is not hot enough
3. You use the steam button too often
1. You are using chemical
limescale remover
2. There are dust fibres in the sole-
plate that have been burnt
3. Your laundry has not been rinsed
fully
adequately rinsed or you are using
starch
4. Demineralised water was used.
1. You are using a too high
temperature
2. You are using starch
Solutions
1. Set the them temperature dial within
the margins of the steam symbol.
2. Wait for the light to go out
3. Wait a few seconds before pressing
the button again.
1. Do not use
limescale remover
2. Clean the sole with a damp sponge.
3. Check that your laundry has been
sufficiently rinsed.
4. Use only tap water or 50/50 tap water/
demineralised water.
1. Clean the soleplate with a damp
sponge
2. Spray the starch on the inside of the
laundry