Domo DO7354M Manual De Instrucciones página 36

· Position the air flow in order to optimise the heating of the room. Avoid corners, small volumes, floors
and ceilings.
· Place the appliance on a smooth, stable surface.
· When the appliance is switched on for the first time, a slight smell may be emitted. Please ensure
sufficient ventilation. This smell will disappear very quickly.
INSTALLATION
Attach the supports with the wheels to the bottom of the appliance using the screws.
USE
1. Set the temperature knob to MIN and the position switch to 0. Plug in the
appliance.
2. Set the position switch to 1 (750 W) or 2 (1500 W).
3. Turn the temperature knob into the desired position.
Overheat protection
This heater is protected with an overheat protection that switches off the heater automatically in case of
overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches off the
temperature inside when the appliance exceeds the normal running temperature. The heating element
will automatically stop working. In this case, unplug the appliance. If this happens, switch off the unit and
wait until it has cooled down sufficiently (±10 minutes). Make sure that the air outlet is not covered. Then
switch it back on as described above. The appliance should operate normally. Should the problem persist,
please contact the nearest customer service.
Tip-over safety
The appliance will turn off when it tips over. When you set the unit upright again, it will go back into
standby mode.
CLEANING AND MAINTENANCE
· Before cleaning the appliance, ensure it has cooled down completely.
· Set the temperature knob to the minimum setting and the switch to 0. Disconnect the appliance from
the power supply.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· Do not use petrol, thinners, corrosive cleaning agents, solvents, or chemicals.
36
DO7354M