Craftsman 27710 Manual De Las Instrucciones página 24

2
1. Frontbagger tube
2. Lower bagger tube
3. 1/4 x 50,8mm Carriage
Bolts
4. 1/4 Lock nut
1. Front bagger tube
2. 1/4 x50,8mm Carriage
Bolts
3. 1/4 Lock nut
4. Vinyl Binding
5. Dump handle tube
6. Clevis pin
7. Retainer spring
1. Top Surfaces Even
2. Horizontal Adjustment Brack-
et
3. Vertical Adjustment Bracket
2
4
6MM (1/4")- 9MM(3/8")
1
_) To Assemble Bagger
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
gether.
Holes in front bagger tube are at an angle. Place front
bagger tube against lower bagger tube and chock for
proper hole alignment before assembling bolts.
Assemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
Tighten securely.
Slide front and lower bagger tube assembly intothe bag-
ger assemby.
Assemble front and upper bagger tubes using four (4)
1/4 x 50,8ram carraige bolts and lock nuts supplied.
Tighten securely.
Slip all the vinyl bindingsover the bagger tubes
Slide the bagger dump handle through the hole in the
bagger top, installthe clevis pin and secure with retainer
spring.
NOTE: For future use, the clevispin may be removedin order
to use the handleto clear the chutein the event it has become
clogged.
Bagger adjustment
For proper bag function and appearance, it may be neces-
sary to adjust the bagger assembly.There should be 6mm
( 1/4")-9mm (3/8")gapbetween the baggertop andfenderand
the bagger top surface should be even with the top surface
of the fender,To adjust bagger position:
Horizontal adjustment
Slightly loosen the nuts securingthe bagger RH and LH
horizontaladjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
Move the brackets the amount forwardor backward you
wish the bag assembly to move. Retighten the nuts se-
curely.
Vertical adjustment
Slightlyloosen the nuts securingthe vertical adjustment
brackets.Loosen onlyenough sothe brackets keeptheir
position,but allow them to be moved.
Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
Reinstall the bagger assembly and check the bagger to
fender fit. If necessary, repeat the procedure untilproper
fit is attained.
To convert to bagging, mulching or discharge
See "Section 5" of this manual.
24