vigo CORNELIUS VG05004 Manual Del Usuario página 5

ASSEMBLY CONTINUE
NOTE: INSTALLATION MUST BE DONE BY A QUALIFIED, LICENSED PLUMBER
5. Attach the handle by placing the handle on
the mixer and securing the set screw.
3. Secure mixer to the wall. 4. Connect spout to the mixer using the supplied
washer. Secure washer behind the threaded
portion of the spout for spacing. Thread the spout
so the tip faces down making sure not to over
tighten the spout to the mixer.
5
SPOUT
6. After installation is complete turn on the
water supply valves and allow both hot and cold
water to run at least one minute each. While
water is running, check for leaks, especially at
hook-ups to supply lines. Tightening nuts
slightly will stop any minor leaks.
HANDLE
SET SCREW