Descargar Imprimir esta página

Troy-Bilt V560 Serie Manual Del Operador página 9

Ocultar thumbs Ver también para V560 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

3_
The rope guide is attached
to the right side of the upper
handle. See Fig. 3-3. Loosen the wing
nut which secures the
rope guide.
Figure
3=3
4_
a.
Hold blade control
against
upper handle.
b.
Pull starter rope out of the engine.
Release blade
control.
c.
Slip starter rope into rope guide.
d.
Tighten
wing nut.
Insert post on cable tie into hole provided
on the lower
handle. Pull cable tie tight and trim excess.
Grass Catcher
Follow steps below to assemble
the grass catcher. Make
certain
bag is turned
right side out before assembling
(warning
label will be on the outside).
a.
Place bag over frame so that its black plastic side is
at the bottom.
b.
Slip plastic channel
of grass bag over hooks on the
frame. See Fig. 3-4. All the plastic channels except
center top of bag attach from outside
of bag.
Figure 3-4
2_
f
c.
Attach center top of bag from inside of bag.
Follow the steps below to attach the grass catcher:
a.
Lift rear discharge
door. See Fig. 3-5.
Figure
3-5
Place grass catcher on the pivot rod. Let go of
discharge
door so that it rests on the grass catcher.
WARNING:
Never operate mower
unless the hooks
on the grass catcher are firmly seated on the pivot
rod and the rear discharge
door rests firmly against
top of the grass catcher.
SECTION
3 -- ASSEMBLY& SET-UP
9

Publicidad

loading