Technical data
Impact drill
Type
Supply voltage (V)
Power frequency (Hz)
Power input (W)
Speed under load (rpm)
1st speed gear
2nd speed gear
Idle speed (rpm)
1st speed gear
2nd speed gear
Number of impacts (ipm)
1st speed gear
2nd speed gear
Speed pre-selection
Right-left turning
Extent of chuck dia. (mm)
Thread on spindle
Quick-tightening chuck Auto-Lock
Drilling dia. max (mm)
into steel
into aluminium
into wood
into concrete
Clamping neck dia. (mm)
Weight (mm)
Protection class
Controls
1 ...........Chuck with ring gear
2 ...........Spots on spindle
3 ...........Clamping neck
4 ...........Lever for impact shifting
5 ...........Air vents
6 ...........Latching pin
7 ...........Switch / controller
8 ...........Speed pre-selection wheel
9 ...........Alteration switch lever
10 .........Gear-shifting lever
11 .........Additional handle
12 .........Stop bar
13 .........Chuck hook
14 .........Spanner
15 .........Socket screw wrench
16 .........Quick-tightening chuck
The displayed or described accessories need not be included in the
delivery package.
Double insulation
To ensure maximum safety of the user, our tools are designed and
built to satisfy applicable European standards (EN standards). Tools
with double insulation are marked by the international symbol of
a double square. These tools must not be grounded and a two-wire
cable is sufficient to supply them with power. Tools are shielded in
accordance with EN 50114.
EVP 13 G-2H3
EVP 13 G-2A
230–240
230–240
50–60
50–60
760
760
0–600
0–600
0–1 750
0–1 750
0–1 100
0–1 100
0–3 050
0–3 050
0–22 000
0–22 000
0–61 000
0–61 000
ü
ü
ü
ü
1.5–13
1.5–13
1/2"-20 UNF
1/2"-20 UNF
û
ü
13
13
25
25
45
45
20
20
43
43
2.1
2.2
II /
II /
Use
The machine is intended drilling in wood, metal, ceramic and plas-
tic. Machines with electronic control and right/left rotation are also
suitable for screwing and thread cutting ( Only for soft screwdriv-
ing applications).
In addition, the machine is designed for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal, ceramics
and plastics. Machines with electronic control and right/left rota-
tion are also suitable for screwing and thread-cutting.
The user alone is responsible for any liabilities caused by usage
other than intended.
Commissioning and use
Any unauthorised use might cause damage to the tool. Therefore
follow these instructions:
- Always use sharp drill bits.
- Load the tool to avoid any significant reduction of speed or
stoppage.
- Always change the speed gear when the machine is idle or at
the machine slow-down at low speed, in no case during the
drilling or when the machine is otherwise loaded.
Check whether the data on the name plate correspond with the
actual power supply voltage. Tools designed for 230 V may be con-
nected also to 220 / 240 V.
Attention! Prior to handling the accessories, the pow-
er supply cable has always to be disconnected from
the power source socket!
Additional handle
For safety reasons always use the additional handle (11), firmly
mounted on the clamping neck (3). The stop bar (12) can be used
to adjust the drilling depth. By rotating the handle the position of
the addition al handle and the depth stop can be modified.
English
15