Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
If burner
does not light or flame is too low, you may
have spider or other insect blockage
in burner, or the
flow limiting device has been activated.
See "Burner
Assembly/Maintenance"
under Proper Care and
Maintenance,
or "Regulator
Resetting
Procedure"
under
Connecting
LP Cylinder and Hose/Regulator
to Grill.
LIGHTING THE MAIN BURNERS:
1.
2.
3.
4.
Open lid before lighting
burner.
Make sure all control knobs are in the "OFF" position.
Push and hold down any MAIN BURNER
control knob and turn
to f "Hi" and you will hear a clicking sound as the burner is
being ignited. Once the burner lights, turn control knob to
desired
setting.
If ignition does NOT occur in 5 seconds,
turn control
knob to
OFF, wait 5 minutes
to allow gas to clear away and repeat
lighting
procedure.
5.
To light other burners,
follow Step 3.
6.
To turn off, turn each control knob clockwise
until it locks in the
"OFF" position. This extinguishes
the flame, but does not turn
off the gas flow from the cylinder. To stop gas flow, you must
turn the cylinder
valve off.
MATCH LIGHTING THE MAIN BURNERS:
1.
2.
3.
4.
5.
6.
7.
Open lid before lighting.
Turn the burner control knobs to "OFF".
Place a paper match in the end of the matchlighter.
Strike the
match and place through lighting
hole in the left hand side of
the grill to approximately
1/2" (1 to 2 cm) from the burner.
Turn on the FAR LEFT burner control
knob to the "Hi" position.
The burner should
light within 5 seconds.
If the burner does not light, turn the control knob to "OFF" and
wait 5 minutes
for gas to clear away and repeat lighting
procedure.
To light other burners,
push and turn control knobs to "Hi" in
sequence
from left to right. Follow Step 5.
If the burner does not light within the first few attempts
of match
lighting,
there is a problem with the gas supply. Turn off the gas
at the burner and cylinder.
DO NOT attempt
to operate the grill
until the problem
is found and corrected.
See "Troubleshooting"
section
of this manual.
Note:
If burner does not light or flame is too low, you may
have spider or other insect blockage
in burner, or the
flow limiting device has been activated.
See "Burner
Assembly/Maintenance"
under Proper Care and
Maintenance,
or "Regulator
Resetting
Procedure"
under
Connecting
LP Cylinder and Hose/Regulator
to Grill.
LIGHTING THE SIDE BURNER:
1.
Open lid before lighting
side burner.
2.
Make sure control knob is in the "OFF" position.
3.
Push and hold down SIDE BURNER
control
knob and turn to
_" "Hi" and you will hear a clicking sound as the burner is being
ignited.
Once the burner
lights, turn control
knob to desired
setting.
4.
If ignition does NOT occur in 5 seconds,
turn control
knob to
"OFF", wait 5 minutes
to allow gas to clear away and repeat
lighting
procedure.
5.
To turn off, turn control knob clockwise
until it locks in the "OFF"
position.
11
MATCH LIGHTING THE SIDE BURNER:
1.
2.
3.
Open the lid to the burner before lighting.
Turn the burner control
knob to "OFF".
Strike and carefully
place a match approximately
1/2"
(1 to 2 cm) from the burner.
4.
Turn the burner control
knob to the "Hi" position. The burner
should light within 5 seconds.
5.
If the burner does not light, turn the control
knob to "OFF" and
wait 5 minutes
for gas to clear away and repeat lighting
procedure.
6.
If the burner does not light within the first few attempts
of match
lighting, there is a problem
with the gas supply. Turn off the gas
at the burner and cylinder. DO NOT attempt
to operate the grill
until the problem
is found and corrected.
See "Troubleshooting"
section of this manual.
LIGHTING THE SMOKER:
1.
Open door before lighting
burner.
2.
Make sure control knob is in the "OFF" position.
3.
Push and hold down SMOKER
BURNER
control knob and turn
to _ "Hi" and you will hear a clicking
sound as the burner
is
being ignited.
Once the burner lights, turn control knob to
desired
setting.
4.
If ignition does NOT occur in 5 seconds,
turn control
knob to
"OFF", wait 5 minutes
to allow gas to clear away and repeat
lighting procedure.
5.
To turn off, turn control knob clockwise
until it locks in the "OFF"
position.
MATCH LIGHTING THE SMOKER:
1.
2.
3.
Open the door to the burner before lighting.
Turn the burner control
knob to "OFF".
Strike and carefully
place a match approximately
1/2" (1 to 2
cm) from the burner.
4.
Turn the burner control
knob to the "Hi" position. The burner
should light within 5 seconds.
5.
If the burner does not light, turn the control
knob to "OFF" and
wait 5 minutes
for gas to clear away and repeat lighting
procedure.
6.
If the burner does not light within the first few attempts
of match
lighting, there is a problem
with the gas supply. Turn off the gas
at the burner and cylinder. DO NOT attempt
to operate the grill
until the problem
is found and corrected.
See "Troubleshooting"
section of this manual.
Note:
Observe
flame height when lit: Flame should
be a Blue/
Yellow color between
1"-2" when burner
is on "Hi".
TURNING OFF THE GRILL:
1.
Turn off the cylinder
valve.
2.
Turn all burner knobs to OFE
Note:
Turn off LP cylinder
first to prevent gas from being
left in the system under pressure.
A'k CAUTION:
The cylinder
valve should
always
be in the off, or closed,
position /
_
,_
when the grill is not in us___
To turn off the cylinder valve,
/
_./
.......
_/
turn knob clockwise
until it stops.
\
./
Publicidad
