Troy-Bilt 020240 Manual De Instrucciones página 12

Section 4: Operation
For generaH rinsing (medium pressure and medium
llow)_ ideaHfor most aHpurpose cleaning such as
home siding_ brick pados_ wood decks, driveways
and sidewaH<s_ garage floors_ etc., sdect orange
GeneraH ProjectPro TM nozzHe (Figure H6),
/
For maximum rinsing (higher pressure and Hower
tlow), for stubborn or hard to reach surface such
as second story surfaces, paint removal oH stains_
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), seHect red Max
ProjectPro TM nozzHe (Figure H7).
4,
PuHH bacH< on collar, insert seHected ProjectPro TMnozzle
and release collar.Tug on ProjectPro TMnozzle to make
sure it is securely in place.
5. For most effective cleaning, keep ProjectPro TMnozzle
from 8 to 24 inches away from cleaning surface. [f you
get the nozzle too close, you may damage the cleaning
surface.
6, DO NOT get closer than 6 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance_ gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the sur[ace you will clean will not be
damased by the high pressure spray by testing in a hidden area.
Pull back collar on quick-connect and pull current
ProjectPro TM nozzle off. Store ProjectPro TM nozzles in
holder provided on the accessory tray.
Pull back on colhr, insert turbo nozzle and release
collar (Figure 19).Tug on turbo nozzle to make sure it
is securely in place.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro TM
cleaning detergent nozzle (Figure 18).
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with turbo nozzle.
How to Use the Rotating and Utility
The rotating and utility brushes allow you to scrub surfaces
with water filtering through the bristles.
To attach a brush to the gum
I. Remove nozzle extension from spray gun, if attached.
2. Attach brush to spray gun.Tighten by hand (Figure 20).