4. Setup Guide
Get Started
1)Pair Netum bluetooth (refer to the section of "Bluetooth pairing")
2)Setup keyboard language: US keyboard is set by default. If you use
other type of keyboard please refer to the section of "keyboard language".
3)Locate cursor on place where you want the data to be displayed after
that you can start to scan.
Firmware Version
Read below command barcode to check scanner firmware version.
Firmware Version
Barcode Programming
Netum barcode scanners are factory programmed for the most common
terminal and communications settings. If you need to change these
settings, programming is accomplished by scanning the bar codes in this
guide. An asterisk (*) next to an option indicates the default setting.
Bluetooth Pairing
How to pair scanner's bluetooth with the dock ?
1) Connect the dock with your computer via USB cable.
(4)