cecotec DRUMFIT X-BIKE 3000 NEO Manual De Instrucciones página 49

3. PRODUCT ASSEMBLY
Step 1: Installing the folding bolt
Fig. 2
Remove the folding bolt as shown in Figure 2 to unfold the exercise bike.
Once in position for use, reinsert the folding bolt.
Step 2: Stabilisers
Fig. 3
Check that the flat part of the non-slip support foot of the stabiliser stays on the ground.
-
Remove the screws from the stabilisers.
-
Place the main frame on the stabiliser and align the holes.
-
Re-insert the screws to fix the main frame to the stabiliser.
-
Securely tighten the screws.
-
Repeat the process with the other stabiliser.
-
Step 3: Installing the handlebar and the control panel.
Fig. 4
Place the handlebar on the frame matching the holes of both as shown in Figure 4.
-
Use the screws and washers supplied to secure both parts.
-
Connect the power cable to the control panel and place the control panel on the handlebar
-
as shown in Figure 4.
Step 4: Pedals
Fig. 5
Attach the left and right pedal to the corresponding crank.
Step 5: Saddle
Fig. 6
Remove the nuts under the saddle.
-
Place the saddle on top of the saddle post as shown in Figure 6.
-
Use the nuts to secure both parts.
-
Step 6: Saddle post
Fig. 7
Insert the saddle post into the main frame as shown in Figure 7.
Do not exceed the STOP mark on the saddle post when adjusting the saddle height.
DRUMFIT X-BIKE 3000 NEO
ENGLISH
49