GB
3. The LEDs on the top of the handset indicate the charging progress.
Option 2: Charging the battery once removed
1. Insert the mains plug into the charging socket at the back of the battery. Open the small protective cover
beforehand. (see fig. B)
2. Connect the mains adaptor to a functioning socket.
3. The LED on the inside of the battery will start to flash. When the battery is fully charged, the LED lights up
continuously. (see fig. C)
Option 3: Charging in the storage station
1. Insert the mains plug into the charging socket on the back of the storage station. (see fig. D)
2. Connect the mains adaptor to a functioning socket.
3. Hang the appliance in the receptacle so that the charging contact is established.
4. The LEDs on the top of the handset indicate the charging progress.
The battery capacity is shown in the display; in addition the battery symbol flashes green.
The display goes off 30 minutes after the battery has been fully charged.
Application
WARNING!
DANGER OF EXPLOSION
Liquids can form explosive vapours or mixtures by swirling with the suction air of the
vacuum cleaner.
Never suck up liquids with the vacuum cleaner.
WARNING!
DANGER OF FIRE
If you vacuum glowing ashes, burning cigarettes or similar with the vacuum cleaner,
the filters may catch fire.
Do not vacuum any glowing or smouldering materials or objects.
NOTE!
DANGER OF DAMAGE
Improper handling of the appliance may cause damage.
Do not vacuum sharp particles.
26
Instruction manual