Publicidad
Idiomas disponibles
Idiomas disponibles
Storage, Transportation, and Mounting
Anti-Kickback Device Storage
(Fig. 31)
When not in use, store the Anti-Kickback Device 27
under the right side of the Table 13.
Attach the Anti-Kickback Device 27 to the Anti-Kick-
back Device Hanging Bracket 65 in the same man-
ner that it attaches to the Riving Knife 25
(See "Attaching the Anti-Kickback Device" on page
19.)
Make sure that the Anti-Kickback Device 27 is se-
curely attached to the Anti-Kickback Device Hang-
ing Bracket 65.
Fig. 31
27
A
B
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 28
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 28
65
65
C
Hex Wrench Storage
(Fig. 32)
When not in use, store the Hex Wrench 32 on the
rear right foot of the table saw's Base 5.
To store the Hex Wrench:
1. Slide the short end of the Hex Wrench 32 into
.
the Hex Wrench Storage Port 66 provided on
the rear right foot of the saw
2. Rotate the Hex Wrench 32 counterclockwise,
and push until the long end of the Wrench 32
snaps into the Hex Wrench Storage Bracket 67
.
Fig. 32
67
-28-
.
B
A
4/20/2023 11:23:26 AM
4/20/2023 11:23:26 AM
32
66
Publicidad
