Publicidad
Idiomas disponibles
Idiomas disponibles
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off when you turn
out the lights.
c. Move charger and battery pack to a location where the surrounding air temperature is
approximately 60°F and 80°F (16°- 27°C).
d. If charging problems persist, take the tool, battery pack and charger to your local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were
easily done previously. DO NOT CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever you desire with no adverse affect
on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil,
or any buildup of metallic particles should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the cavity. Unplug charger before
attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
warning:
ShOck hazard. Do not allow any liquid to get inside charger. NeVeR ATTemPT
To oPeN THe BATTeRy PACk FoR ANy ReAsoN. IF THe PLAsTIC HoUsINg oF THe BATTeRy
PACk BReAks oR CRACks, ReTURN To A seRVICe CeNTeR FoR ReCyCLINg.
inStalling / reMOving battery pack
warning:
inStalling battery.
tO inStall battery pack:
Insert battery pack into tool until fully seated and an audible click is heard
(figure A). Make sure battery pack is fully seated and fully latched into position.
tO reMOve battery pack: Depress the battery release button in the back
of the battery pack and pull battery pack out of tool.
State Of charge indicatOr
The battery is equipped with a state of charge indicator. This can be used
to display the current level of charge in the battery during use and during
charging. It does not indicate tool functionality and is subject to variation based on product components,
temperature and end-user application
checking State Of charge during uSe (figure b):
• Press the state of charge indicator button (B1).
• The four LEDs (B2) will illuminate indicating the percent of charge in the
battery. See chart in figure B.
• If LED light does not illuminate, charge battery.
aSSeMbly
nOte: Ensure the sweeper is switched off and the battery is removed before attaching or removing
the sweeper tubes. The tube assembly must be assembled to the housing before use.
• tube aSSeMbly: To attach the inner tube to
the sweeper, line up the tube with the sweeper
housing as shown in figure C. Push the tube into
the sweeper housing until the lock button engages
the lock hole in the tube. Repeat this process for the
outer tube.
Make certain the tOOl iS Switched Off befOre reMOving Or
C
7
A
B
B2
B1
Publicidad
