Publicidad
Idiomas disponibles
Idiomas disponibles
•
Attachments 11 to 17 can be used with the hand appliance.
•
These parts can be fitted to adapter 10.
•
First fit the adapter onto the bushing on the appliance.
The adapter can only fit in one position.
•
You can now select and attach an accessory.
•
The multi-purpose attachment 11 can be combined with
parts 12 or 13.
Release the attachments
•
Parts 8, 9 and 11 to 17 can be easily detached.
•
Other parts, such as the foot, are secured to the counter-
part with a button.
•
Press the button and pull the parts apart.
Initial Operation
Fill in Water
NOTE:
•
The maximum filling capacity is 300 ml. Use the measur-
ing cup provided.
•
Recommendation: Use distilled water to prevent calcification.
CAUTION:
Do not use battery water, water from tumble dryers or water
with additives such as cleaning agents, alcohol, fabric
softener or other chemicals. They could cause hazards or
damage to the appliance.
WARNING: Risk of injury!
1. Disconnect the mains plug from the wall socket.
2. If the appliance is still warm, wait approx. 5 minutes until
removing the lid.
3. The cap on the tank can be screwed on. Pay attention to
the attached symbols.
4. Fill water up to the maximum mark.
5. Close the tank.
WARNING:
• Always remove the mains plug before cleaning the device.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
Electrical Connection
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the device to a duly installed protective contact
socket.
CAUTION:
•
Prevent damage and ensure that the appliance is also
suitable for this surface!
•
Test the cleaning action first on a concealed area!
•
Do not hold the steam nozzle for too long and too close
in one position.
1. Press the switch
2. The steam mop is ready for use after approx. 30 seconds.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be filled up as follows:
1. Press the switch
2. Remove the mains plug from the socket!
3. Fill water up to the maximum mark.
4. Connect the plug to the socket again and switch the appli-
ance on to continue operation.
When you have finished using the device
1. Press the switch
2. Remove the mains plug from the socket!
3. Let the unit cool down completely.
4. Empty the water tank.
Cleaning
•
Before the device is put away or cleaned it must have
completely cooled down.
•
Clean the appliance and accessories with a slightly damp
cloth.
Using the Device
.
.
.
27
Publicidad
