Publicidad
Idiomas disponibles
Idiomas disponibles
I_1
Always
exercise
Lubrication
extreme care
Lubrication procedures must be ob-
when using any solvent or thin-
ner. Never clean gun near fire,
flame, or any source of heat or
sparks. Properly dispose of
used cleaning materials.
DO NOT soak
entire spray gun
in solvent or thinner for a long
period of time as this will de-
stroy lubricants and possibly
make motion uneven. NEVER
use lye or caustic alkaline solu-
tion for cleaning. Such solutions
will attack
aluminum alloy parts
of gun.
It is important that spray gun be
cleaned after daily use. Cleaning is ac-
complished
by spraying appropriate
solvent or thinner through system.
Wipe exterior of spray gun with
solvent soaked cloth or use cleaning
brush(s) provided to remove any accu-
mulated material.
Cleaning
(a) Empty material from gravity feed
cup and replace with a suitable
solvent.
(b) Operate trigger until all material
traces have disappeared
and gun
is thoroughly
clean.
(c)
Clean air cap with brush.
IMPORTANT: Make certain air cap
and fluid nozzle are kept clean at all
times. If necessary, remove these
two components
and soak them in
solvent. DO NOT use hard objects
to clean clogged holes. The
smallest amount of damage may
cause irregular spray pattern.
NOTE: If fluid nozzle is to be re-
moved for thorough
cleaning, squeeze
trigger to prevent damage of fluid
needle tip when unscrewing
nozzle.
served after thoroughly cleaning the
gun to ensure effective, high quality
performance of spray gun.
1.
Lubricate working points with
straight mineral oil, or castor oil.
2.
Periodically, place a few drops of
oil on tapered sections of fluid
nozzle to ensure easy operation of
air cap. When spraying water
base materials, coat fluid nozzle
inside and
outside with straight
mineral oil after each use.
3.
Outer diameter of needle sleeve
of fluid needle assembly must be
lubricated occasionally
with
straight mineral oil.
Change
or Replace
nozzle
set
When changing nozzle set, make sure
the complete nozzle set is exchanged.
A set includes an air cap, fluid nozzle,
and fluid needle. NOTE: Assemble
fluid nozzle before putting in fluid
needle.
Nozzle
Sets
Part
Orifice
Material
Number
Diameter
*D26395
15 mm (059")
high solids,
multipurpose
D26397
1.7 mm (.067")
primers
D26398
2.0 mm (.079")
latex, acrylics,
enamels
D26399
2.2 mm (.087")
heavy primer,
mastics, and
latex
Standard size is supplied with gun. Other
nozzle sets should be ordered
separately. A set includes an air cap, fluic
nozzle, and fluid needle.
Exchange of the self-tensioning
needle packing
The fluid needle seal is effeeted by a
Teflon packing with self-tensioning
compression
spring. To change the
packing during general overhaul,
please use the socket
spanner pro-
vided.
D28996
6* ENG
Publicidad
