IPC ML CMP D1521P T 3x230V Manual De Instrucciones página 26

USING THE HIGH PRESSURE WASHER
CONTROL PANEL
A - ON/OFF switch
STARTING THE HIGH PRES-
SURE WASHER
1) Open the water supply tap
(fig. 2A).
2) Connect the high pressure
washer to the mains electricity
supply by an omnipolar switch
or by plugging it into the mains
socket..
3) Turn the high pressure
washer on by turning the ON/
OFF switch to the "I" position
(fig. 4A).
! Warning
The water jet generates recoil
on the lance. Hold the lance
handgrip firmly.
4) Press the handgrip trigger
and start washing.
! Warning
In high pressure washers with
the Total Stop system, the mo-
tor starts and stops when the
trigger on the lance handgrip
is pressed or released.
!
Danger
Do not block the handgrip trig-
ger in the delivery position.
IMPORTANT INFORMA-
TION!
To eliminate impurities or air
bubbles from the hydraulic
circuit, start up the high
pressure washer for the first
time without the lance and
allow the water to flow out
for a few seconds.
Impurities could block the
nozzle and prevent it from
operating (fig. 5).
English
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat 25° angle jet
for cleaning large surfaces.
!
Warning
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head with rotary
nozzle to clean the most stubborn dirt. .
!
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
FIG. 4
Do not aim the jet at people, animals or electrical sockets.
STOPPING THE HIGH PRESSURE WASHER
1) After using with detergent, rinse the suction circuit. Place the
detergent suction hose in a container of clean water and operate
the pump for a minute with the detergent tap fully open and the
lance in the detergent delivery phase.
2) Turn the high pressure washer off by turning the ON/OFF
switch to the "0" position (fig. 4).
3) Release the pressure in the H.P. hose by pressing the gun
trigger.
4) Disconnect the high pressure washer from the mains electri-
city supply by the omnipolar switch or unplugging it from the
mains socket.
5) Close the water supply tap (fig. 2A).
! Warning
When you leave the high pressure washer unattended even
briefly, turn it off by the omnipolar switch and unplugging it from
the mains socket.
! Warning
High pressure washers with
Total Stop device are consi-
dered off when the omnipolar
switch is in the "0" position
or when unplugged from the
mains socket.
! Warning
When the high pressure
washer is not in use, close
the safety device on the han-
dgrip (fig. 6).
! Warning
Operating the high pressure
washer without water se-
riously damages the pump
gaskets.
FIG. 5
- 22 -
FIG. 6