Publicidad
Idiomas disponibles
Idiomas disponibles
GRASS
CATCHER
The grass catcher may be hosed with
water, but must be dry when used.
Check your grass catcher often for dam-
age or deterioration.
Through normal
use it will wear.
If catcher needs replac-
ing, replace only with approved replace-
ment catcher shown in the Repair Parts
section of this manual.
Give the lawn
mower model number when ordering.
GEAR
CASE
1. Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Remove oil fill cap/dipstick;
lay aside
on a clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
• To keep your drive system working
properly, the gear case and area around
the drive should be kept clean and free
of trash build-up.
Clean under the drive
cover twice a season.
• The gear case is filled with lubricant to the
proper level at the factory.
The only time
the lubricant needs attention
is if service
has been performed on the gear case.
ENGINE
Maintenance,
repair, or replacement
of the
4.
emission control devices and systems, which
are being done at the customers
expense,
5.
may be performed by any non-road engine
repair establishment
or individual. Warranty
6.
repairs must be performed by an authorized
engine manufacturer's
service outlet.
LUBRICATION
Use only high quality detergent
oil rated
with API service classification
SG-SL.
Select the oil's SAE viscosity grade
according to your expected operating
temperature.
SAE VISCOSITY GRADES
4O
°F
-_0
0
3O 3_4O
_0
8O
,00
°C
=30
=2;
=1;
;
1'0
20
10
TEMPERATURERANGEANTICIPATEDBEFORENEXTOILCHANGE
NOTE:
Multi-viscosity
oils (5W30, 10W30
etc.) improve starting in cold weather, and
you should check your engine oil level fre-
quently to avoid possible engine damage
from running low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase
oil level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE
ENGINE OIL
NOTE:
Before tipping lawn mower to drain
oil, empty fuel tank by running engine until
Wipe off any spilled oil from lawn
mower or side of engine.
Fill engine with oil. Slowly pour oil
down the oil fill spout into the engine.
Wait one minute to allow oil to settle.
Use guage on oil fill cap/dipstick
for
checking
level.
Insert dipstick into
the tube and rest the oil fill cap on the
tube.
DO NOT thread the cap into the
tube when taking reading.
Oil fill cap /
dipstick
Upper _
mark
7. Continue adding small amounts of
oil and rechecking
the dipstick until it
reads full. DO NOT overfill, or engine
will smoke on startup.
8. Always be sure to retighten oil fill cap/
dipstick before starting engine.
9. Reconnect spark plug wire to spark
plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter every 100 hours of
operation or every season, whichever
oc-
curs first. Service air cleaner more often
under dusty conditions.
fuel tank is empty.
14
Publicidad
