Troy-Bilt 020241 Manual Del Operario página 14

SPECiFiCATiONS
Max Outlet Pressure ..................... 2600 psi
Max Fmow Rate .......... 2.5 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply ................ Not to Exceed IO0°F
Automatic Cool ............. Will cycle when water
Down System reaches 125°° I 5S°F
Shipping Weight ........................... 70 Ibs,
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing
components on your TroyoBilt pressure washer, please call
1-888-611-6708 for assistance.
o Some adjustments will need to be made periodically to
properly maintain your pressure washer. Check the spray
gun and nozzle extension assembly for wear.
o All maintenance in this manual and the engine operator's
manual should
be made at least once each season.
o Once a year you should clean or replace the spark plug,
dean or replace the air fiiter_A new spark plug and dean
air filter assure proper fuel:air mixture and help your
engine run better and Hast longer. Please refer to your
engine operator's manual for more details.
o [f equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before
Each
Use
I. Check engine oil level.
2. Check water inlet screen for damage.
3. Check inoline filter for damage.
4. Check high pressure hose for leaks.
5, Check chemical injection hose and filter for damage,
6, Check spray gun and nozzle extension assembly for
leaks.
7, Rinse out garden hose to flush out debris,
PRESSURE WASHER
MAINTENANCE
Check and Clean
Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clog$ed or replace it if screen is damaged.
_h Pressure Hose
The high pressure hose can develop leaks from wear.
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover.
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Rephcement hose rating MUST exceed maximum pressure
rating of unit.
_ent Siphonin 8 Tube
Examine the filter on the detergent tube and clean if
do&led.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears, Replace the filter or
tube if either is damaged,
Check
Gun
and
Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the tri&!_er by pressing it and making
sure it "springs back" into place when you release it. Put
the tri&ser lock in the ON position and test the tri&ser.You
should not be able to press the triter.
Check
In-Line Filter
Refer to Figure 14 and service the inoline filter if it
becomes clo_ed, as follows:
Nozzle Extension