Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2.Tilt the water container,pour out the condensate water into the basin.
3. Install the water container.
• Empty the water container after each use. Once the water container is filled
completely, the programme will be paused and the "FUL" icon will light. After the
container is emptied, the dryer can be restarted by pressing Start/Pause button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.
Clean the lint filter
Fig.11
1. Open the door.
2. Take out the filter.
3. Open the filter and remove the fluff on the filter, you can clean it in water.
4. Dry the filter thoroughly before installing it back.
• The lint accumulated on the filter will block the air circulation, which will cause the
extension of drying time and increase energy consumption.Therefore the lint filter
shall be cleaned after each use.
• Take notice of the correct orientation before to insert the lint filter.
• Do not operate the dryer without the lint filter!
• Clean the lint filter after each use to prevent lint accumulation inside the dryer.
Cleaning the heat exchange
Fig.12
Leave the dryer to cool down.
Residual water may leak out, place an absorbent cloth under the maintenance cover.
1. Unlock the maintenance cover.
2. Completely open maintenace cover.
3.Turn both locking levers towards each other.
4. Pull out the heat exchanger.
5. Flush the heat exchanger with water to remove lint;
let the water drain properly.
6. Clean the seals.
7. Re-insert the heat exchanger, the handle at the bottom.
8.Turn both locking levers.
9. Close the maintenance cover until it locks into position.
Please clean the heat exchanger approximately, once every 3 months if frequently
35
SECADORA EVVO NATURE S8C / S8CX
Publicidad
