Publicidad
Idiomas disponibles
Idiomas disponibles
The PRO Timer II is a digital timer for highest demands. Its smallest time setting is one second. The unit
GB
has 8 freely programmable time slots that can be used either as a regular timer or as an Interval Control.
This makes it excellent for controlling rain systems. An internal battery ensures reliable saving of the
settings also if power is lost.
Operating conditions
• The device may only be operated at 240V / 50 Hz AC Voltage
• The device may be operated in any position, but it has to be ensured that it is impossible for it to fall into water.
• The ambient temperature limit during operation may not fall below and exceed 0°C and +55°C respectively.
• The device is designed for use in dry and clean rooms.
• At formation of condensed water a period of acclimatisation of up to 2h has to be ensured.
• Protect the device from moisture, spray water and impact of heat!
Installation:
• If the display shows nothing, please plug in the device into the power socket and press the RESET button.
• Set weekday and clock (see "Setting Weekday & Clock")
• Make the desired timer programming (see Setting Timer or Interval Control)
• Plug the device into a suitable wall socket
• Plug the to be controlled device into a the socket of the timer
Setting Weekday & Clock
Keep „CLOCK" pressed and press the corresponding buttons to set the clock and weekday. "WEEK" will switch through
the week days, „HOUR" the hours, „MIN" the minutes and „SEC" through the seconds.
Select Timer function or Interval Control
Attention! There are 8 switching points available that can be programmed either as a normal timer or as Interval Control.
It is not possible to programme the individual switching points in different Modes!
Press the „SETUP" button. The unit jumps to the current programming. If the unit is in Interval Control, an "INT" is shown
on the left of the display. If no such sign appears, the unit is in the normal timer function. If the unit already shows the
function you want to use, you can start programming immediately. In the other case, you must press „CLOCK" to get out
of programming again. If you then press the key combination „SETUP+MODE", you switch between the two functions
Interval Control and timer. If the display disappears briefly, you are sure that you have pressed both „SETUP+MODE"
keys simultaneously. If you then press „SETUP" again, you are in the other function.
Please note that every time you switch between timer and Interval Control, all existing programming is deleted!
Setting Timer
Press the „SETUP" key and make sure that the unit is in timer Mode (no "INT" is displayed on the left, see above). If
necessary, switch the unit as described above.
Press „SETUP" to switch through the available timer slots. In the display the number of the Slot will appear and ON or
OFF next to it. "1 ON" will bet he start time for the first slot, „1 OFF" the stop time. Repeatedly pressing "SETUP" will
allow you to switch through all available 8 time slots.
For programming press „SETUP" till you have reached the desired timer slot. Now press the corresponding buttons to
set time and day: "HOUR" for hours, "MIN" for Minutes and "SEC" for the second. By pressing "WEEK" you can choose
the day the program should be active.
If the desired time is set, press "SETUP" again to set the time and day the timer should switch off the device. Follow the
same procedure to program more time slots if desired.
5
Publicidad
