Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
2.
A.
Align the chute deflector in position on the discharge opening and
2.
A.
Align the chipper chute over the weld studs, so the slot in the bottom of
insert hex bolt with spacer through hinge on chute deflector (spacers fit
the chute is facing down. See Figure 6.
inside of hinges). See Figure 4.
Figure 6
B.
Secure chipper chute with the three cupped washers (cupped side
against the chipper chute) and hex nuts previously removed.
B.
Place second spacer over hex bolt inside other hinge and secure with
Do not tighten the nuts at this time.
hex lock nut.
Figure 4
C.
Secure both sides of chute deflector to impeller housing using wing
knobs previously removed.
Attaching The Chipper Chute
1.
A.
Remove the three cupped washers and hex nuts from weld studs around
the opening on the side of the impeller housing. See Figure 5.
Figure 5
B.
Remove the hex bolts, flat washers, and lock nuts from the two holes on
the upper end of the support brace.
Publicidad
