Publicidad
Important DOS and DON´TS
Numbers in brackets after names of parts correspond to those used in the acompanying assembly drawings and/or
spare parts lists.
1.
The machine is switched on by pressing the trigger. Never support the machine on this part when connected to the
air line, since this could lead to unintentional operation.
2.
Damaged parts must be immediately exchanged for new original replacements by trained personnel.
3.
The machine must not be used without silencer.
4.
Keep hands, loose garments and long hair away from drill steels.
5.
MH3/1: Using a retaining cap you have to screw the o-ring tighttly to the retaining cap to avoid unintentional
loosening.
MK4/1: Make sure that the is screwn tightly to the ring to avoid uninterntional loosening.
M/H/K/5/2 – M/H/K/6/2: Make sure that the retaining cap are screwn tightly to the ring to avoid intentional
loosening. Using the closed retaining cap make sure that the buffer in the retaining cap is assembled.
6.
Before switching on press the machine against the material to be machined so as to prevent it from recoiling or
slipping.
7.
Never lubricate with combustable media.
8.
Allow only trained personnel to operate the machine.
9.
On completion of the job in hand disconnect the air hose from the machine so as to prevent its unauthorized
operation.
10. Before switching on keep the machine pressed against the material to be machined as otherwise the steel could
result in injury of personnel as it shoots forward.
11. Never fill air hoses with compressed air unless connected up to machine.
12. Make sure all hose connections are tight before switching on.
13. Operate the machine with the hands only. All other parts of the body must be kept at a safe distance.
14. The hammer is for machining rock, earth and concrete. To avoid injuries make sure that no other energy toures (e.
g. gas or water pipes, power lines, etc.) are damaged by the operation. ATTENTION: The machine is not insulated
against electric current.
15. Avoid worn and blunt steels as they can course harmful vibrations, which reduce the power of the tool and
increase the wear of the parts.
16. Use only tools; which are specified for the use with this machine.
17. Never use the hammer without the retaining cap and accordingly the retaining cap in connection with the
adequate tool!!!!!!!!! Using shanks A15 (MH3/1) as E15, E13,9 and E115 (M4/1, M5/2 and M6/2) as well as A17,5 and
A20 (M5/2 and M6/2 just one retaining ring is used. Attention: To carry these processes out the tools have to be held
down and necessarily with the hand to starting.
erstellt/revidiert 02/09/2011
5
Publicidad
