Lenco DAR-017 Manual Del Usuario página 9

Initial use
Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
Switch the device on with the power switch on the rear.
Basic operation-getting started
Basic operation-getting started
1. Connect the mains adaptor to the DC IN socket, fully extend the telescopic antenna, plug in and
switch on at the mains.
2. The display backlight will illuminate and the clock (00:00:00) (Time is not set) will flash
3. On the very first use the DAB mode will automatically be selected and the radio will perform a
full scan. The display will show 'Scanning' with a bar indicator showing the scan progress and
the total number of stations found.
4. When the scan is finished the radio will play the first alphanumerically found station. If the
radio does not find any stations, 'No DAB Station' will be displayed.
5. Adjust the volume to the desired level using the VOL(+/-) knob.
6. Press the stations button and use knob to scroll through the stations list. Press the OK knob on
your favorite station.
7. Press the Mode button to switch between DAB, FM, and Bluetooth mode,
8. Press the Standby button to go into 'Standby' mode.
9. Press Sleep to set the Set Sleep Timer: Use Volume knob and rotate to choose between Sleep
off-15 minutes-30 minutes-45 mintues-60 minutes-90 minutes. The radio will go into standby
when the selected minutes have been counted down.
Using the radio- DAB mode
DAB Mode- Full scan
This function will scan for all available DAB stations, Band III channels.
9