Toshiba RAV-SM562UT-E Manual De Instalación página 9

External view
Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not put a heavy article on the indoor unit. (Even units are packaged)
• Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, be
sure to use buffering cloth, etc. to not damage the unit.
• To move the indoor unit, hold the hooking metals (4 positions) only.
Do not apply force to the other parts (refrigerant pipe, drain pan, foamed parts, or resin parts, etc.).
• Carry the package by two or more persons, and do not bundle it with PP band at positions other than
specified.
Knockout square
Ceiling bottom surface
hole for divide duct
For Ø150
(2 positions)
C
97
Ceiling bottom
surface
Considering pipe/wire connecting work inside the ceiling after the indoor unit has been hanged, select an installation
place and determine piping direction.
• If the ceiling has already been set before hanging the main unit, prepare refrigerant pipe, drain pipe, indoor
connecting wire, remote controller cord, etc. up to the place where pipe and wire can be connected.
• Check the size of the indoor unit, and match the indoor unit size, with ceiling opening size and that position using
the attached installation pattern.
(Attach the pattern to the lower side of indoor unit with attached four screws M5 x 16L.)
REQUIREMENT
Ø162
240
105
840 Unit external dimension
723 Hanging bolt pitch
950 Panel external dimension
860 to 910 Ceiling opening dimension
480
Ceiling panel (sold separately)
Ceiling bottom surface
80
Ø162
105
Electric parts box
E
381.6
Hanging bolt
M10 or Ø3/8
227
(To be procured locally)
6
173
113
Refrigerant pipe
connecting port
A
Refrigerant pipe
connecting port
B
105
130
Knockout square hole
for divide duct
For Ø150
210
Drain pipe connecting port
Model
A B
RAV
SM562UT-E Ø6.4 Ø12.7 120 256
SM802UT-E Ø9.5 Ø15.9 120 256
SM1102UT-E Ø9.5 Ø15.9 120 256
SM1402UT-E
Ø9.5 Ø15.9 183 319
SP1102UT-E Ø9.5 Ø15.9 183 319
45
Take-in port
of pipes
Ceiling
bottom
surface
(mm)
C D E
434.5
434.5
434.5
415
415