Gima WT221A Manual Del Usuario página 5

5
SETTING UP YOUR TABLE
Steps are as below:
1 2
1. Release the latch.
2. Lay the table on its side with two rubber feet on the floor, open up the table with four legs extended
as fully as possible. Take out all accessories.
3. Lift the table up to position with all legs on the floor.
4. Put the accessories into the corresponding lodging, fasten the hanging armrest or sling on the
headrest cradle.
5. Release the side handle and push it in once the headrest has been adjusted to the required position.
6. Now the table is ready for your use.
The height of the table is adjustable by turning the knobs on the leg and taking out the movable leg to
adjust the height, by choosing the holes on the movable leg. Then reinsert the leg and firmly fasten the
knobs. All four legs should be adjusted in the same way, one by one, being sure to adjust all legs at
the same height level.
CLOSING AND TRANSPORTING THE TABLE
1. Lift up the backrest to the maximum position and then push it down, lock
the latch.
2. Take out all accessories.
3. Lay the table on its side with the two of the rubber feet on the ground.
4. Put all accessories under the elastic strap beneath the top veneer.
5. Fold the legs on each end internally by pressing the corresponding support
arms.
6. Fold the table up and lock the latch.
7. The table can be carried like a suitcase by grasping the handle.
Warning: If the frame/legs/table structure is damaged in any way, the table
should not be used. Using this table when damaged may cause harm or se-
rious injury to you or your patient. It should be repaired immediately.
GIMA WARRANTY TERMS
The Gima 12-month standard B2B warranty applies.
ENGLISH
3 4 5 6