Publicidad
1.
Front bagger
tube
2.
Vinyl binding
5
3.
Spreader
bars
"',
4.
Retainer
spring
4
5.
Vinyl binding
7
8
\
6.
Dump
handle
tube
7.
Clevis
pin 10 x 44mm
8.
Retainer
spring
9
9.
Cap
1.
Top Surfaces
Even
2.
Horizontal
Adjustment
Bracket
3.
Vertical
Adjustment
Bracket
4.
Bagger
Latch
6MM
(I/4")
- 9MM
(3/8")
®
To Assemble
Bagger
Unfold bag by pivoting front bagger tube alltheway forward
and pressing the bottom vinyl binding onto the tube.
Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
Press the vinyl bindings onto the sides of front bagger
tube.
Slide
the bagger
dump
handle
through
the hole in the
bagger
top, install the clevis
pin 10 x 44mm
and secure
with retainer
spring.
Push cap over end of bagger
dump
handle.
NOTE:
For future use, the clevis pin may be removed
in order
to use the handle to clear the chute in the event it has become
clogged.
Bagger
adjustment
For proper
bag function
and appearance,
it may be neces-
sary to adjust
the bagger
assembly.
There
should
be 6mm
(1/4")-gmm
(3/8") gap between
the bagger top and fender and
the bagger
top surface
should
be even with the top surface
of the fender.
To adjust
bagger
position:
Horizontal
adjustment
Slightly
loosen
the nuts securing
the bagger
RH and LH
horizontal
adjustment
brackets.
Loosen
only enough
so
the brackets
keep their
position,
but allow
them
to be
moved.
Move the brackets
the amount
forward
or backward
you
wish the bag assembly
to move.
Retighten
the
nuts se-
curely.
Vertical
adjustment
Slightly
loosen
the nuts securing
the vertical
adjustment
brackets.
Loosen
only enough
so the brackets
keep their
position,
but allow them
to be moved.
Move the brackets
the amount
up or down you wish the
bag assembly
to move.
Retighten
the nuts securely.
Reinstall
the bagger
assembly
and check the bagger
to
fender
fit. If necessary,
repeat the procedure
until proper
fit is attained.
After
proper
fit is attained,
remove
bagger
from tractor
and install bagger
latch (4) to tractor
back plate as shown.
Tighten
securely.
Install and carefully
lower bagger
to actuate
latch.
Measure
distance
between
bagger
and latch as shown.
If distance
is not 10mm - 16mm carefully
remove
bagger
and repeat
vertical
adjustment
as needed.
IOMM (7/16") - 16MM (5/8")
To convert
to bagging,
mulching
or discharge
25
See "Section
5" of this manual.
Publicidad
