Campbell Hausfeld IRONFORCE WL6500 Serie Instrucciones Para La Operación página 5

WL6500 Series
Maintenance
The compressor should be checked
often for any visible problems and the
following maintenance procedures
should be performed each time the
compressor is used,
1. Pull ring on safety valve and allow it
to snap back to normal position.
Safely vJIve must
be r_pla(_l If It
cannot be actuated or it leaks a(r • fter
rfng is released.
2. Place unit in the horizontal position
as shown in Figure 8. With
compressor shut off and pressure
released: Drain moisture from tank
by opening drain co(k underneath
tank.
3. Turn power OFF and clean dust and
dirt from pump cover, tank and air
lines.
IMPORTANT: Unit should be located as
far from spraying area as hose will
allow to prevent over-spray from
clogging filter.
LUBRICATION
This is an oilless type compressor
requiring no lubrication.
STORAGE
t. When not in use, hose and compres-
sor should be stored in a cool dry
place.
2. Tank should be drained of moisture.
3. Hose should be dlsconnected and
hung open ends down, to allow any
moisture to drain.