Publicidad
Idiomas disponibles
Idiomas disponibles
THE LASER GUIDE
Your saw is equipped with a Laser cutting
guide using a Class 11 laser beam. The laser
beam will enable the operator to preview the
path of the saw blade on the stock to be cut
before starting the saw. This laser guide is
powered by transformed alternating current
supplied from the mains power source. The
saw must be connected to the power source
and the laser on/off switch must be turned 'On'
for the laser line to show.
To turn the LASER 'On', slide the LASER On/
Off switch towards the 1' position.
To turn the LASER 'Off' slide the switch
towards the 'O' position. (Fig. V)
WARNING I
Laser is radiated when the laser guide is
turned on. Avoid direct eye contact into
the laser beam. Always unplug the saw
from the power source before making any
adjustments.
Laser Warning Label:
Max output <1 mW 630-670nm.
Complies with 21CFFI 1040.10 and 1040.11.
@
(Fig. V)
NOTE: All adjustments for the operation of the
laser guide have been completed at the factory.
If you have any problems or questions
regarding the laser guide, call the Sears
Service Center.
The use of optical instruments with this laser
could increase the eye risk hazard.
Do not attempt to repair or disassemble
the laser. Entrust any repairs required to a
Sears Service Center.
Use the Laser only as specified in this
Instruction Manual. Use of the laser in
any way not specified in this Instruction
Manual could result in hazardous radiation
exposure.
30
Publicidad
