3.3.1.
SBS-LAB-107 / SBS-LAB-108
Use the MENU and ↑ ↓ buttons to set the desired speed and time.
Switch on the device with the START/STOP button. Use the same button to turn off the device after work.
Disconnect the device from the power source when not in use.
3.3.2.
SBS-LAB-111:
Use the MENU and ↑ ↓ buttons to set the desired speed, time and temperature.
Switch on the device with the START/STOP button. Use the same button to turn off the device after work.
Disconnect the device from the power source when not in use.
3.3.3.
SBS-LAB-113 / SBS-LAB-114:
Turn on the device using the switch on the back of the device. Use the same button to turn off the device
after work.
Disconnect the device from the power source when not in use.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all parts should be thoroughly dried before the device is reused.
d)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any damages.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
j)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils, or other chemicals. It
may cause damage to the device.
k)
CAUTION! If there is a concern that the device is contaminated with toxic, radioactive or other
substances that are harmful to health, immediately sterilize the equipment in accordance with the
applicable laboratory methods.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by
the symbol on the product, operating instructions, or packaging. The materials used in this appliance are
recyclable according to their marking. By reusing, recycling, or applying other forms of use of waste
machines, you make a significant contribution to the protection of our environment.
Your local administration will provide you with information about the appropriate disposal point for used
appliances.
EN