1
NOTES
• Button design is based on a typical model and may slightly vary from the actual one
you purchased.
• All the functions described can also be accomplished using the unit's control panel.
If the unit is without this feature, there will be no corresponding operation when
pressing the relevant button on the remote controller.
• When there are significant differences between features or operation implied by
the remote control illustration and the actual functions described in the USER'S
MANUAL, the descriptions in the USER'S MANUAL shall prevail.
• The device may comply with local national regulations. In Canada, it should
comply with CAN ICES-3(B)/NMB-3(B). In USA, this device complies with part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications not approved by the party responsible for compliance
could void users authority to operate the equipment.
ENERGY SAVER OPERATION
In this mode, the fan will continue to run for 3
minutes after the compressor shuts off. The fan
then cycles on for 2 minutes at 10 minute intervals
until the room temperature is above the set
temperature, at which time the compressor turns
back on and cooling resumes.
Page 29