GE Profile 405 Manual Del Propietário página 9

i i iiii ii1,1,,11111,11111111 iiiiiiiiiiiiiiiiiiii i1,11
Drying Rack-on some models
A handy drying rack may be used for drying
articles such as stuffed toys, pillows or
washable sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.
NOW.:
[] The drying rock must be used with the
TIMEDCYCLE.
n Do not use this drying rack when there are
other clothes in the dryer,
About the dryingcenter (on some models).
....................................... ii I I IIIII I II IIII II IIIIIIIIIIIIIIIII1'111111
A WANNING!
[] Do not overload the Drying Center. It may be damaged if more than 20 lbs, are applied°
[] Always store the Drying Center in a safe position so that it does not hit anyone.
[] Do not allow children to play with the Drying Center.
The pole on the Drying Center can be set at different heights. Line up the tabs on
the pole with the notch on the brackets (this will occur when the pole is pamlle! to
the control panel) and raise or lower the pole, resting the tab on the bracket at the
heightyou want,
The Drying Center can be mounted on either side of the dryer.
Toremove and transfer the Drying Centerto the opposite side;
[_] Remove the pole by raising it up. Make sure to line up the tabs on the pole with the
notches on the bracket,
[]Remove the four screws that secure the bracket to the dryer° Three of the screws wil!
be required to motmt the bracket on the other side. The fourth screw at the top of
the side panel flange (shown in circled illustration) needs to be put back into its
original location_
: !:i
[_]On the other side of the dryer remove the screw at the top of the side panel flange
(shown in circled illustrafion)_
[]Turn the bracket upside down and attach it with the screw you just removed and with
the three screws that were removed from the other side.
A WANNING!
Make sure you use only these screws_ Never use any long screws (must be less than 3/8") or
pointed screws.
[_--]Insert the pole into the mounting bracket.
9