Publicidad
Idiomas disponibles
Idiomas disponibles
choke l ever totheOFF C HOKE
posi-
tion. Allow the unit t orun for30more
seconds atthe OFF C HOKE
position
before squeezing
and releasing
the
throttle trigger torelease the throttle
lock. N OTE: Ifengine dies with the
choke l ever i nthe OFF C HOKE
posi-
tion, move t he choke l ever tothe
HALF CHOKE
position and pull t he
rope until engine runs, but n omore
than 6pulls.
STARTING
A WARM ENGINE
1. Move the ON/OFF switch to the ON
position.
2. Slowly press the primer bulb 6
times.
3. Move the choke lever to the HALF
CHOKE position.
4. Engage the throttle lock as directed
in STARTING A COLD ENGINE.
NOTE:
Keep the throttle lock engaged
until the engine starts.
5. Pull starter rope sharply until engine
runs, but no more than 5 pulls.
6. Allow the engine to run 10 seconds,
then move choke lever to the OFF
CHOKE position.
7. Release the throttle lock by squeez-
ing and releasing
the throttle trigger.
NOTE:
If engine has not started, pull
starter rope 5 more pulls. If engine still
does not run, it is probably flooded.
Pro-
ceed to STARTING A FLOODED ENGINE.
STARTING
A FLOODED
ENGINE
Flooded engines can be started by
placing the ON/OFF switch in the ON
position and the choke lever in the OFF
CHOKE position and engaging
the
throttle lock as directed in the START-
ING A COLD ENGINE section; then, pull
the rope to clear the engine of excess
fuel. Starting could require pulling the
starter rope many times depending
on
how badly the unit is flooded.
If the unit still doesn't start, refer to the
TROUBLESHOOTING TABLE or call
1-800-235-5878.
CUSTOMER
RESPONSIBILITIES
_t WARNING:
Ensure ON/OFF switch is in the OFF position and disconnect
the spark plug before performing
maintenance
except for carburetor
adjust-
ments.
CARE & MAINTENANCE
TASK
WHEN TO PERFORM
Check for loose fasteners and parts
Before each use
Check for damaged
or worn parts
Before each use
Inspect and clean unit and labels
After each use
Clean air filter
Every 5 hours of operation
Inspect muffler and spark arresting
screen
Every 50 hours of operation
Replace spark plug
Yearly
Replace fuel filter
Yearly
GENERAL
RECOMMEN
DATIONS
The warranty on this unit does not cov-
er items that have been subjected
to
operator
abuse or negligence.
To re-
ceive full value from the warranty, the
operator
must maintain
unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically
to
properly
maintain your unit.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
CHECK
FOR DAMAGED
OR
WORN PARTS
Contact Sears Service
Center for re-
placement
of damaged
or worn parts.
• ON/OFF Switch - Ensure ON/OFF
switch functions properly by moving
the switch to the OFF position. Make
sure engine stops; then restart engine
and continue.
• Fuel Tank - Do not use unit if fuel tank
shows signs of damage or leaks.
INSPECT
AND CLEAN
UNIT AND
LABELS
• Before and after each use, inspect
complete
unit for loose or damaged
parts.
Publicidad
