Epson OT-BX88 Manual De Instalación página 5

Introduction
The OT-BX88 is a power supply cover (PS-Cover) to be attached under the
TM-T88IV printer to hold the power unit. This manual describes the
procedures and precautions for installing and using the OT-BX88.
Before using the product, read this manual carefully so that you will use the
product properly. Keep this manual available for reference.
This manual consists of 11 languages, with all of the illustrations, other than
those in "Unpacking" on page 2, at the beginning of this manual. Some of the
illustrations have numbers in them. See the list below for the meaning of the
numbers.
1. Power unit
2. Hook
3. DC cable
4. Core
5. Projection
Key to Symbols
The symbols in this manual are identified by their level of importance, as
defined below. Read the following carefully before handling the product.
WARNING:
You must follow warnings carefully to avoid serious bodily injury.
CAUTION:
Cautions must be observed to avoid minor injury to yourself, damage to
your equipment, or loss of data.
Note:
Notes have important information and useful tips on the operation of your equipment.
Safety Precautions
WARNING:
Use this product only for the TM-T88IV. Do not use for other products or other
purposes. Doing so may cause equipment damage and burning.
Use only the PS-180 as the power unit with this product. Be sure to read the "Usage
Precautions for the PS-180 Power Unit" for usage of the PS-180 to use it safely.
Never disassemble or modify this product. Tampering with this product may
result in injury or fire.
Do not allow foreign matter to fall into the equipment. Penetration by
foreign objects may lead to fire.
OT-BX88 Installation Manual
Copyright © 2006 by Seiko Epson Corporation
6. Fixing tape
7. Screw hole
8. Connector cover
9. Projection
OT-BX88 Installation Manual 1
English
English