Publicidad
Idiomas disponibles
Idiomas disponibles
5. Installing
the chuck
WARNING:
Before any assembly
of the chuck and arbor to the drill
press head, clean all mating surfaces
with a non-petroleum
based
product;
such as alcohol
or lacquer thinner. Any oil or grease
used
in the packing
of these parts must be removed;
otherwise
the chuck
may come loose during operation.
5.1 Open the jaws of the chuck by rotating the chuck sleeve clockwise.
To prevent damage, make sure the jaws are completely receded into
the chuck.
5.2 Push the chuck shaft into the spindle.
5.3.Use a wooden mallet to firmly tap the chuck securely into place in the
spindle. See Fig. 6.
NOTE:
To remove
chuck
perform
the following:
- Rotate the chuck sleeve clockwise until the jaws recede completely into
the chuck.
- Lower the spindle as far as it will go to reveal the spindle slot, See Fig.6A
- Raise the table to a position just below the the chuck.
- Insert the tip of the chuck removal tool into the spindle slot above the tip
of the chuck shaft.
- Tap on the blunt end of the wedge tool until the chuck releases from the
spindle,
6. install
knob
for the head assembly
lid. Fig. 7
7. Flexible
lamp
Install the flexible
lamp
7.1. Connect the lamp plug contact to the power source plug contact in
the drill head as shown,
7.2. Use four pan head screws to install the lamp assembly to the drill
head as shown,
7.3. Turn on the flexible lamp switch to check the lighting. Fig. 8
Figure
6
Figure
6A
I
Figure
7
Figure
8
Publicidad
