Publicidad
Idiomas disponibles
Idiomas disponibles
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an appropriate insulation
board
• Do not cover the ventilation holes at the top of the appliances – it must be a good air circulation
around the appliance. There should be a gap of at least 10 cm between the top of the appliance
body and any furniture that may be above it. If this requirement is not followed, the appliance
consumes more electrical energy and its compressor may overheat.
• If the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance
body and the wall (see page 1, fig. 3).
• The appliance must stand on a level surface and must not touch the wall. If necessary, regulate
the height of the appliance by adjusting the levelling feet: by turning them clockwise – the front of
the appliance rises, by turning them counter clockwise – it comes down. If the appliance is tilted
slightly backward – the doors will close by themselves.
PREPARING THE APPLIANCE FOR OPERATION
It is recommended to prepare the appliance for operation with a helper.
• Remove package. Lift the appliance away from foamed polystyrene base. When placing, moving,
lifting the appliance, do not hold the door handles, do not pull the condenser at the rear
part of the refrigerator and do not touch the compressor unit. Therefore take out adhesive
tapes from sides and simply lift the appliance up and take out the board. Strip adhesive tapes
off and open the door.
• When positioning the appliance in chosen location, it will move more easily into position if you lift
the front a little and incline it backward allowing it to roll on its casters.
• Take two supports from the bag (see page 1, fig. 2) and insert them into the guides at the top
back part of the appliance.
• The appliance should not be connected to the mains until all packing and transport materials
aren't removed.
First use:
•
Before using the appliance for the first time, the interior and all internal accessories should be
washed with lukewarm water and some neutral soap to remove the typical smell of a
brandnew product, then dried thoroughly
Wait at least 4 hours before connecting the appliance to the power
supply. This is to allow the oil to flow back in the compressor.
The temperature in the refrigerator compartment is controlled using the thermostat knob 2 (see fig.
1) by turning it to one side or the other. The temperature indication in digits is shown beside the
thermostat knob. When the door is closed, the temperature setting can be seen on the thermostat
indicator display 3 (fig. 1).
The temperature is regulated on the scale of five digits.
0 = Compressor is switched off. WARNING! Electric current is not switched off.
1 = highest temperature (lowest cooling)
5 = lowest temperature (highest cooling)
The temperature in the refrigerator compartment may vary depending on ambient
temperature, the amount of foodstuffs, the temperature of the foodstuffs, and how often the
appliance doors are opened and closed.
IF THE ROOM IS COOL, THE APPLIANCE COOLS LESS. THE TEMPERATURE IN THE APPLIANCE MAY
THEREFORE RISE. Use the thermostat wheel to set a lower temperature.
TEMPERATURE REGULATION
.
21
Publicidad
