Reimo Victoria Manual Del Usuario página 14

7. INSTALLATION STEPS
DE
EN
IT
ES
FR
1) Please check if there are
FI
optional racks on car roof and
the distance between the rack
and the car roof is bigger than
DK
3cm. Otherwise you need
suitable roof racks and mount
them first.
SE
4) Slide the M8x50 bolts to
appropriate position from the
end of the connection tube, 2pcs
at each end.
Please be noted, when the
distance between roof rack and
car roof is less than 4cm, the
short bolts M8 x 30 will be used
instead of the long bolts M8x50.
6) Insert the plastic cap (30x30 cm) into the
end of the connecting tubes.
2 people are needed for the assembly.
2) Loosen the screws according
to the direction and size of the
roof rack and adjust the direc-
tion and distance of the two
connecting-tubes and tighten
the screws. Then carry the tent
onto the car roof.
5) Pass the bolts through the hole of the U-shaped fixing
plate, flat washer then spring washer in proper order, then
tighten the M8 self-locking nut using a ratchet wrench.
Please be noted total 4 pcs U-shaped fixing plates need to
be fixed.
3) Adjust the tent to appropriate
position on the car roof.
(Make sure the trunk door can
be opened.)
M8 Flat gasket
M8 Spring washer
M8 self-locking nut
14