Cable Gland Assembly - DIMOEL MOOV-B300 120V Manual Del Usuario

A1 Antenna
A2 Antenna shield
Opening command for a standard
L1 connection device with switch
normally open.
Pedestrian opening command for a
L2 standard connection device with
switch normally open.
L3 STOP command. N.C. switch
L4 Photocell. N.C. switch
Edge. Switch N.C. or resistive rubber
L5
edge
L6 Commands common (-) line
24 VAC power output for photocells
L7 - L8
and other accessories
Power supply for functional test TX
L8 - L9
photocell
L10 - L11 12V electric lock

CABLE GLAND ASSEMBLY

The casing can accept 4 cable glands in the special
easy-break housings.
The type of cable gland is indicated in the figure.
PLEASE NOTE:
• Remove the electronic circuit board before drill
the casing.
• Drill the container using a suitably sized cutter,
according to the dimensions of the cable gland.
• Fix the cable glands using the special nuts.
K1 - K2 Courtesy light timer activation switch
K3 Motor 1 open
K4 Motor 1 common
K5 Motor 1 close
K6 Motor 2 open
K7 Motor 2 common
K8 Motor 2 closed
K9 - K10 230V - 40W / 120V - 40W blinker
N 230V / 120V power supply - neutral
L 230V / 120V power supply - phase
J1 NOT USED
PLEASE NOTE: If not used, the normally closed
inputs (STOP, PHOTO, EDGE) must be jumpered
with the commands common line COM (-)
21