Publicidad
Idiomas disponibles
Idiomas disponibles
5. Raise attachmentlift leverto its highest
position.
6. Removekey from bag and start the
engine (see "TOSTARTENGINE"in
the Operationsectionof this manual).
After engine has started, movethrottle
controlto idle position.
7. Releaseparking brake.
8. Slowly depressforwarddrive pedal and
drivetractor off skid.
9. Apply braketo stop tractor and set
parking brake.
10.Turnignition key to "STOP"position.
Continuewith the instructionsthat follow.
ASSEMBLE
FRONT
WHEEL
TO
MOWER
1.
Using shoulder
bolt, washer
and
Iocknut from parts bag, assemble
front
wheel to mower
as shown. Tighten
securely.
/
NOTE:
Be sure mower
side suspension
arms (A) are pointing
forward
before
slid-
ing mower
under tractor.
4.
Slide mower
under tractor
until it is
centered
under tractor.
5.
FIRST
INSTALL
ANTI-SWAY
BAR (S).
- From right side of mower,
insert
ant-sway
bar into hole in transmission
bracket
(T).
INSTALL
MOWER
AND
DRIVE
BELT
See MOWER
AND DRIVE
BELT AS-
SEMBLY
Supplement
Sheet for additional
guidance
on this assembly.
Be sure tractor
is on level surface
and
engage
parking
brake.
1.
Lower
attachment
lift lever to it's lowest
position.
A CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly
and engage
in lowest
position.
2.
Turn steering
wheel
to the left as far as
it will go and position
mower
on right
side of tractor
with deflector
shield
to
the right.
,
Remove
plastic
tie securing
belt, bring
belt forward
and check
belt for proper
routing
in all mower
pulley grooves.
- Pivot bar towards
you and insert
other
end of bar into hole in rear mower
bracket
(D). Move mower as needed
to
insert
bar.
- Secure
with washer
and retainer
spring
as shown.
6. ATTACH
MOWER
SIDE SUSPENSION
ARMS
(A) TO CHASSIS
- Position
hole
in arm over pin (B) on outside
of tractor
chassis
and secure
with washer
and
retainer
spring.
9 7.
Repeat
on opposite
side of tractor.
Publicidad
