Operating The Machine; Important; Using The Wand - Nilfisk-Advance L/A 114 Instrucciones De Uso

OPERATING THE MACHINE

1 To release the Power Cord (12) from the Cord Hooks (2), press the Handle Lock Button (4) in while pushing down on the Handle (1) or
turn the lower cord hook (2) and pull the power cord off the hooks. Plug the Power Cord into an electrical outlet.
2 Turn the Main Power Switch (17) ON. "l" is ON and "O" is OFF.
3 Step on the Pedal (11) and tilt the handle back. The Green Light (8) on the base will come on to indicate that the brush motor is running.

IMPORTANT !

Foot pedal must be used to release base to operating position. Failure to do so could result in damage to the handle release
mechanism.
4 Turn the Height Adjustment Knob (10) to adjust the height of the brush. If the Red Light (7) comes on, slowly turn the Knob in the opposite
direction until the light goes off.
If the red light stays on continuously, there may be debris wrapped around the brush. This can cause the overload protector for the brush
motor to trip. If this occurs, turn the Main Switch OFF and unplug the power cord. Remove any debris from the brush and turn the Main
Switch back ON. This will automatically reset the overload protector. The machine can also be reset by locking the handle in the upright
position. Remove any debris from the brush and repeat Step 3. If the overload protector trips repeatedly, or if the red light stays on
continuously, contact Nilfisk-Advance for service.
5 Change the bag whenever the "Bag Full" Light (15) comes on.
If the light comes on before the bag is full, the inside of the bag may be coated with very fine dust (change the bag), or debris may be built
up somewhere between the brush and the bag.

USING THE WAND

To use the Wand (13), put the Handle in the upright locked position. The brush motor will stop automatically. Slide the Wand out of its holder.
Install the Crevice Tool (14) or Dusting Brush (22) on the end of the Wand, if desired.
17 - FORM NO. 56041337 - LA 114/118