Publicidad
Idiomas disponibles
Idiomas disponibles
• Make sure beforehand that there are no cables in the wall that
could be damaged during installation.
• Drill the holes at a height of 2 m above the floor.
• The distance to the ceiling and walls should be at least 30 cm.
1. Drill two holes with a diameter of 6 mm at a dis-
tance of 315 mm.
2. Provide the holes with the wall plugs and the
screws. Leave the screws protruding about 10 mm from the wall.
3. Hang the appliance with the recesses (A) on the
screws. Now push the appliance in direction (B) to fix it.
- When you want to take the appliance off the wall
again, slide it from (B) to (A) and then lift the appliance off the
wall.
Remote control
The lithium cell in the battery compartment
of the remote control has been secured with
a plastic film for transport. This prolongs the
life of the battery. Before using the remote
control for the first time, the plastic film must be removed so
that it is ready for use.
When operating the appliance, make sure that there is a
clear line of sight between the remote control and the sen-
sor in the display of the appliance. When the range of the
remote control decreases, the battery must be changed. To
change the battery, proceed as follows:
1. Press the lock in the direction of the
arrow (1).
2. Pull the holder for the button cell out of
the remote control (2).
3. Replace the cell with a battery of the
same type (CR 2025). Make sure that
the polarity is correct.
4. Push the holder back into the battery compartment until
it clicks into place.
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Set the mains switch on the right side of the appliance to
the O position.
3. Connect the mains plug with a properly installed earthed
socket.
PC-HL3116_IM
Switching the Appliance On
• Set the mains switch on the right-hand side of the appli-
ance to position I. The appliance starts the motor to close
the air flap, which may still be open. The appliance then
switches to standby mode.
• The appliance is operated via the remote control.
Easy Operation
You can also switch the appliance on and off without the
remote control. To do so, press the START / STOP button
next to the mains switch.
1. Press the button to switch the appliance on.
The appliance switches on with the temperature setting
HIGH, fan (FAN) and swinging of the air flap (SWING).
2. Press the button again to switch the appliance off. The
FAN mode is started for 30 seconds and the air flap is
closed. The appliance then switches to standby mode.
Notes for Use
• The appliance is equipped with overheating protection.
When the ambient temperature reaches 51 °C, the
appliance switches off.
• Avoid opening doors and windows during heating opera-
tion, as this will impair the heating effect.
• The current ambient temperature is displayed.
• The appliance always starts in fan mode.
• Settings can only be made during operation.
13
29.06.23
Publicidad
